Installation Engine Compartment Lower; Apply Liquid Gasket To Oil Pan; Install Oil Pan; Install Oil Pressure Switch Extension - Toyota pmn Installation Instructions Manual

15. Installation engine compartment lower

K
K
14x
R
U K
K
K

1. APPLY LIQUID GASKET TO OIL PAN.

(a) Apply the liquid gasket onto the clean sump surface.
NOTICE: Liquid gasket 08826-00080

2. INSTALL OIL PAN.

(a) Within 3 minutes after applying the liquid gasket install
R
the oil-sump onto the engine using the 14 bolts and 2
nuts.
R: Bolt (14 pcs.)
R: Nut (2 pcs.)
(b) Tighten the bolts and nuts carefully first with 5 Nm and
after with the final torque.
Torque: 9 Nm
(c) Install plastic flywheel cover.

3. INSTALL OIL PRESSURE SWITCH EXTENSION.

(a) Remove oil pressure switch.Use Special tool (SST
09816-30010)
R: Oil pressure switch
(b) Install the oil-pressure switch extension into the oil
filter housing using Loctite 243.
K: Extension(15-2)
Torque: 13 Nm
(c) Remove oil filter.Use special tool (SST 09228-06501)
U: Oil filter
(d) Install a new oil filter.
K: Oil filter (26-7)
4. INSTALL OIL PRESSURE SWITCH EXTENSION
BOLT.
(a) Route the oil pressure tube towards the adapter.
(b) Insert the hollow bolt with the 2 copper seal rings into
the adapter using Loctite 243.
NOTICE: When applying the correct torque
onto the hollow-bolt ensure that the
adapter is secured against further
rotation and that the pressure tube is
pointing into the correct direction.
K: Hollow-bolt (15-1)
K: Seal rings (2 pcs.) (15-3)
Torque: 20 Nm
49