Air Hose And Clamp; Oil And Coolant - Toyota pmn Installation Instructions Manual

1.5. AIR HOSE AND CLAMP.

NOTICE:
– Follow the instructions below. Otherwise the hose may come off or intake air may leak, disabling
driving due to engine stop.
– Wrapping the hose clamp too tightly may damage the part or related parts.
Example:
Paint mark

1.6. OIL AND COOLANT.

Reuse the oil and coolant if it is judged possible from their condition.
3-5mm
(a) The paint mark on the air hose is the reference for positioning.
(b) When fitting the hose to the pipe, make sure to push in the hose
(c) Unless otherwise specified in this manual, fit the hose clamp at
Paint mark
3-5mm
(d) When tightening the hose clamp, check the illustration in this
Align the mark with that of the pipe for fitting.
until it reaches the paint mark. If there is no paint mark on the
pipe, push the hose to the end.
3 to 5 mm (0.118 to 0.197 In.) from the end of the hose.
HINT:
Do not wrap the hose clamp around the hose at a slant.
manual and make sure the position and orientation of the screw
is appropriate for on-vehicle maintenance.
HINT:
Tighten the hose clamp until the end of the clamp reaches
the paint mark, in order to ensure optimal tightening
condition.
27