Table of Contents
Advertisement
Operation
6.3
34
03.00|Clamping device SVP-Mini auto/SVP-RM auto|en
Clamping and loosening the tool
NOTICE
Material damage due to missing or contaminated polygonal jaw
chuck!
The intermediate sleeve may deforms when clamping without in-
serted polygonal jaw chuck. Contaminated polygonal jaw chucks
lead to a heavy wear of the intermediate sleeve. The clamping de-
vice is no longer functional.
• Do only insert clean polygonal jaw chuck.
• Do only build up pressure if the polygonal jaw chuck is inserted
• Push the polygonal jaw chuck into the clamping device up to the
stop.
NOTE
• Please observe the operating time of the pump in continuous
mode,
( 3, Page 16)
• In case of a high operating time, the power supply unit heats up.
The pump turns itself off. As soon as the power supply unit is
cooled down, the pump turns on again.
• Observe operating and assembly manual of TRIBOS polygonal jaw
chuck!
Clamping device
1 SVP-RM auto
3 Polygonal jaw chuck
2 SVP-Mini auto
4 Intermediate sleeve
Advertisement
Table of Contents
