Back Panel And Bottom Panel; Leds - NETGEAR ProSAFE M4200 Series Hardware Installation Manual

• One AC power receptacle

Back Panel and Bottom Panel

The switch integrates a fixed, internal power supply unit (PSU) and a fixed, side-to-side fan.
The back panel does not contain any components other than two mounting holes that allow
for horizontal or vertical attachment to a wall, rectangular pole or table leg, or round pole or
table leg. The bottom panel also contains mounting holes to allow for attachment. For more
information, see Step 4: Install the Switch on page 21.
The following figure illustrates the back panel with the mounting holes.
Figure 2. Back panel
The following figure illustrates the bottom panel with the mounting holes.
Figure 3. Bottom panel

LEDs

The following table describes the LEDs on the front panel.
Table 1. LEDs
LED
Power
Fan
Hardware Overview
Managed Switch Series M4200
Designation
• Solid green . The power module is present, is supplying power to the switch,
and is functioning normally.
• Solid yellow . The switch is booting.
• Blinking yellow. The system boot-up failed or another failure occurred.
• Off . Power is not supplied to the switch.
• Solid green . The fans are functioning normally.
• Blinking yellow. One or more fans failed.
• Off . Power is not supplied to the switch. The fans are off.
12 Hardware Installation Guide