Hardware Overview; Hardware Features - NETGEAR ProSAFE M4200 Series Hardware Installation Manual

Hardware Overview

The ProSAFE Managed Switch Series M4200 consists of a single model, the
M4200-10MG-POE+ switch.
This model provides six 100M/1G/2.5GBASE-T RJ-45 PoE ports, two
100M/1G/2.5G/5GBASE-T RJ-45 PoE ports, and two 10GBASE-X fiber SFP+ uplink ports in
a full-width chassis that can be freestanding, attached to a wall, round pole, or even a table
leg, or installed in a 1U rack.
A typical use of this switch is as a 10G aggregation switch for 802.11ac Wave 2 access points
and NBASE-T endpoints at the WiFi edge of a campus network or a network of a midsize
organization. The switch is IEEE compliant and offers low latency for high-speed networking.

Hardware Features

The switch includes the following key hardware features:
• The switch provides following traffic ports:
- Six 100M/1G/2.5GBASE-T RJ-45 PoE ports
- Two 100M/1G/2.5G/5GBASE-T RJ-45 PoE ports
- Two dedicated 10GBASE-X fiber SFP+ uplink ports
• 90G switching fabric (all ports line-rate).
• One out-of-band 1G Ethernet port.
• One RJ-45 RS232 console port.
• One mini-USB console port.
• One regular USB port for connection to a storage device.
• Full-width chassis for desktop operation,
or equipment room, or attachable almost anywhere with a mount.
• Full compatibility with IEEE standards:
- IEEE 802.3u (100BASE-TX)
- IEEE 802.3ab (1000BASE-T)
- IEEE 802.3an (10GBASE-T)
- IEEE 802.3z (1000BASE-X)
- IEEE 802.3 Clause 49 (10GBASE-LR and 10GBASE-SR)
- IEEE802.3ae (10GBASE Ethernet)
- IEEE802.3az (Energy Efficient Ethernet)
- IEEE 802.3x (Full-duplex flow control)
- IEEE 802.1af (PoE)
Introduction
Managed Switch Series M4200
wall operation, rack-mounting in a wiring
6
closet
Hardware Installation Guide