Table of Contents
Advertisement
FS752TP Front-Panel and Back-Panel Configuration
The FS752TP has:
•
48 10/100 Mbps copper ports
•
Ports 49, 50 with RJ45 connectors that support 10/100/1000 Mbps
•
Ports 51 and 52 with RJ45 connectors that support 10/100/1000 Mbps only
•
Two SFP ports (Combo ports). The SFP combo ports are shared with copper ports 49 and
50. If the SFP combo ports are in use, copper ports 49 and 50 are inactive.
Each port is capable of sensing the line speed and negotiating the duplex mode with the link
partner automatically.
Figure 2
illustrates the front panel of the NETGEAR FS752TP.
Power/Status LED
Factory Defaults
Button
Reset Button
Figure 2. Front Panel
The front panel contains the following:
•
48 RJ-45 connectors for 10/100 Mbps autosensing Fast Ethernet switching ports
•
Two SFP combo Gigabit Ethernet switching ports
•
Two dedicated 1000 Mbps Gigabit Ethernet switching ports
•
Reset button to restart the device
•
Recessed Factory Defaults button to restore the device back to the factory defaults
•
Link, Speed, and Activity LEDs for each port
•
Power and Status LED
•
Fan
•
PoE Max LED which is activated when less than 7W of the available PoE power remain
unused.
•
LED Mode
Figure 3
illustrates the NETGEAR FS752TP back panel.
FS752TP Smart Switch
10/100 Mbps copper ports
Physical Description
10
Combo Ports
Advertisement
Table of Contents
Troubleshooting
