Step 4: Install The Switch; Install The Switch On A Flat Surface; Attach The Switch To A Wall - NETGEAR ProSAFE M4200 Series Hardware Installation Manual

• Console cable with one DB9 connector and one RJ-45 connector
• USB console cable with one mini B connector and one type A connector
• Rubber caps for the SFP / SFP+ sockets
• Rack-mounting kit
• Mount for attachment to a wall, round pole, or table leg
• Rubber belts
• Hose clamps
• Rubber footpads for tabletop installation
• Installation guide
5. If any item is missing or damaged, contact your local NETGEAR reseller for replacement.

Step 4: Install the Switch

You can install the switch on a flat surface, attach it to a wall, attach it to a rectangular or
round pole or table leg, or mount it in a standard 19-inch (48.26-centimeter) network
equipment rack.

Install the Switch on a Flat Surface

The switch ships with four self-adhesive rubber footpads.
To install the switch on a flat surface:
Stick one rubber footpad on each of the four concave spaces on the bottom of the switch.
The rubber footpads cushion the switch against shock and vibrations. They also provide
ventilation space between stacked switches.

Attach the Switch to a Wall

The switch ships with a mount to which you can click-attach the back or bottom of the switch.
To install the switch to a wall:
1. Attach the supplied mount to the wall, either vertically or horizontally, by doing the
following:
a. Place the mount on the wall where you want to mount the switch.
b. Mark the wall where the two mounting holes are.
c. Attach the mount to the wall using the M4 x L25 mm screws provided in the product
package.
d. Tighten the screws with a No. 2 Phillips screwdriver to secure the mount.
2. Click-attach the switch to the mount by doing the following:
Installation
Managed Switch Series M4200
21 Hardware Installation Guide