Identification; Magnetometer Calibration; About Mcube Osm App - Mcube MM8003 User Manual

4.2.6

Identification

The identification feature is designed to find the target MM8003 within a short period if there
are multiple MM8003 nearby the mobile device. User can click 'Identify' in the 'Settings' page
to trigger this feature. Once the identification command is received by MM8003, status LED
would blink in bright blue for 1 minute.
4.2.7

Magnetometer Calibration

This command is only required when MM8003 running in AHRS (9DOF) mode and the status
LED is blinking in red which indicates poor magnetism quality.
Step 1. Click 'Calibration' in the 'Settings' page to trigger this feature. Once the magnetometer
calibration command is received by MM8003, status LED would keep in red for 30 secs for
calibration. User needs to rotate MM8003 in all direction until the status LED resume blinking in
blue or green. If MM8003 is still blinking in red after 30 seconds, user needs to send the
calibration command again or to reboot the MM8003.
Step 2. Once the status LED indicates that MM8003 is in wake-up status, user needs to leave
MM8003 on steady platform for several seconds to calibrate sensors. Once the calibration
process is done, MM8003 will start to update the value of Euler angles.
4.2.8

About mCube OSM APP

Related information includes application version number, contact window and third-party
software license are shown in the 'About' which is located at the upper right-hand corner in
'Settings' page.
mCube Proprietary
© 2019 mCube Inc. All rights reserved.
APS-045-0032V1.0
MM8003 User Manual
24