MM8003 User Manual
Step 6. Click Install and wait the last page of toolbox to appear.
Figure 7: Installation Completion
3.3 How To Use mCube OSM Toolbox
This section describes how to use the features provided by the toolbox after MM8003 is
connected to computer including real-time raw data and Euler angles plotting, 3D object
display, data logging and module configuration updating. OSM toolbox can be started by
'mCube OSM' shortcut on the desktop or 'mCube' folder from Start Menu.
3.3.1
Connect to MM8003
Step 1. Click 'Search Port' and select the 'OSM' COM port following the default setting in Table
3 to choose the baud rate.
Note: If the MM8003 is configured already and the baud rate is not at 115200 as default, the
status LED will blink in yellow indicating wrong command status after is connected. User needs
to disconnect the MM8003 and switch to the correct baud rate before reconnecting.
Figure 8: COM Port and Baud Rate to Connection
11
mCube Proprietary
APS-045-0032V1.0
© 2019 mCube Inc. All rights reserved.