Table of Contents
Advertisement
AirPrime MC Series Dev Kit Quick Start Guide
18
3. Insert one end of the flat flex cable (pins facing up) into any of the three
connectors on the Mini Card Host Extender:
a. Push the cable forward, between the tabs of the brown clip on the
connector. As you move the cable forward, you will feel some slight resis-
tance as it moves into the connector and the clip tilts slightly upward.
Figure 2-12: Attaching a host extender to a Mini Card
b. When the cable is seated firmly in the connector, push down on the arms
of the brown clip to lock the connector in place.
4. Insert the other end of the flat flex cable into connector CN9 on the Dev Kit
board using the same method.
Figure 2-13: Attaching a host extender to the Dev Kit
To disconnect the flat flex cable from the Mini Card Host Extender or Dev Kit
board:
1. Pull up on both arms of the brown clip on the connector at the same time to
release the cable.
2. Pull the flat flex cable straight out of the connector.
Configure the Mini Card
The Dev Kit includes several switches and jumpers that you can use to configure
the Mini Card's operation, as detailed in
on page 21, and
Figure 2-15
Schematic diagram
on page 25.
Note: Some Dev Kit features are available for certain Mini Cards only. For example, the
Audio and UART features are only available for voice-enabled Mini Cards.
Proprietary and Confidential
Table 2-1
on page 19 through
on page 21. For a detailed schematic of the kit, see
Table 2-5
2130705
Hide quick links:
Advertisement
Table of Contents
