Switching The Development Kit On; Rf Communications With The Hl6528X; Configure The Com Port; Figure 26. Cn601 And Sw601 - Sierra Wireless AirPrime HL Development Kit User Manual

Development Kit User Guide
4.2.

Switching the Development Kit On

The Development Kit will automatically be powered on if Pin 1 and Pin 2 of CN601 are connected with
a jumper. Otherwise, push SW601 for approximately 2 seconds to power the Development Kit on.
Figure 26. CN601 and SW601
Two green LEDs, D403 and D501, are lit when the Development Kit has been properly powered on
and is ready for use.
Figure 27. D403 and D501
4.3.

RF Communications with the HL6528x

4.3.1.

Configure the COM Port

Configure the COM port settings by selecting the port which is connected to the Development Kit and
specifying the following port settings.

Bits per second

Data bits

Parity

Stop bits

Flow control
4114877
CN601
SW601
D403
D501
115200
8
None
1
Hardware
Rev 5.0
Getting Started with the HL Series
Development Kit
October 12, 2015 36