3D Histech Pannoramic MIDI User Manual page 10

Pannoramic MIDI 1.18 User's Guide
Disconnect plug!
Warning!
Warning!
Caution!
Caution!
Crush hazard!
Warning!
Warning!
Warning!
April 3, 2014 - Rev 1
Remember to unplug the power cord before you open the Pannoramic MIDI
base unit or replace a fuse!
Only connect external devices that are safety extra low voltage rated to the
instrument to avoid the risk of electrical shock.
The Pannoramic MIDI does not include any special facilities to protect from
samples with an etching, potentially infectious, toxic, radioactive or other
health-damaging effect. You are under obligation to comply with all currently
binding legislation, notably, national accident prevention rules when handling
samples of this kind.
Dirt or dust may adversely impact the operating capability of the Pannoramic
MIDI. For this reason, measures must be taken to eliminate such influences to a
maximum possible degree. During periods of non-use, the Pannoramic MIDI
must be protected with a dust cover. Check that power is turned off before you
put the cover on.
Avoid touching the lamp bulb. Disconnect power and allow the bulb to cool
down by waiting for about 15 minutes before replacing it.
There is crush hazard in the movement area of the slide insert during operation.
Please note that the digitizing process has to be interrupted and the insert
moved via software to the output position before removing the insert.
A defective Pannoramic MIDI is not classified as domestic waste. It must be
properly disposed in accordance with currently valid legal requirements.
The Pannoramic MIDI may not be operated by other than properly instructed
persons. Operating personnel must be fully aware of the potential dangers
which a particular field of application involves. The Pannoramic MIDI is a
precision instrument which may suffer a significant reduction in operational
functions or even physical destruction following intervention performed in any
nonconforming manner.
If an HXP 120 fluorescent illumination unit is used, the corresponding warnings
included in the manufacturer's operating manual have to be observed.
3DHISTECH Ltd.
Character Formats and Symbols
10(127)