Table of Contents
Advertisement
Projects can be loaded even while the sequencers are running.
♪: The
MIDI Control Center [p.126]
Project should be loaded instantly or wait until after the (drum) sequencer reaches the end of its current
Pattern. See the
6.1.2. Saving a Project
!: When you follow the instructions below you will overwrite the selected Project and all its Patterns.
Before you save your Project, make sure that is what you want to do! If you don't want to overwrite
the selected Project, be sure to find out which memory location is empty and store your Project there
instead.
To save a Project:
•
Hold down the SAVE button, then
•
Press the Project button.
The Screen will now ask you to confirm that you want to save the current Project. If that's
OK, press the encoder to confirm your decision or press the Exit button to cancel.
To recall this Project later, follow the procedure described in the
section above.
After pressing the SAVE button (in the Control section), to perform the actual save operation,
press the selection encoder (to the right of the OLED display above the Control Section). A
warning screen will then appear, asking you whether you really want to save. Press the
selection encoder a second time to make the save.
!: Saving a project will save all edited Patterns. It's a quick way to make certain you save all your
changes.
6.1.3. Copying a Project
You can also copy a Project from one location to another, whether you have just edited it or
not. You can only copy the currently loaded Project to a chosen destination Project.
To copy one Project to another, hold down the Copy button and press the Project button.
Pressing the Copy button will change the screen to show the currently loaded Project as well
as the destination Project. The destination Project number will always be the current Project
number +1. Press the selection encoder to confirm the copy operation. A warning message
will ask if you really want to perform the copy. If so, press the selection encoder again to
confirm, or hold down SHIFT and press Exit/Undo to cancel the copy operation.
Warning! If Project 16 is current and you want to save it, it will be stored to Project 1, overwriting all
existing data in Project 1 in the process. ♪: PASTE has no function at Project level.
92
has a parameter that allows you to specify whether the new
Wait to Load Project [p.102]
section to learn about this feature.
Loading a Project [p.91]
Arturia - User Manual Keystep Pro - What is a Project?
Advertisement
Table of Contents
