Table of Contents
Advertisement
9.4. Store To/Recall From
These two buttons enable you to send and recall projects to and from the KeyStep Pro.
CAUTION: The Store To/Recall From transfers cannot be performed while the KeyStep Pro is running.
9.4.1. Storing a Project to the KeyStep Pro
The upper left-hand section of the MIDI Control Center has a button called 'Store To'. Right
above that is a list that allows you to specify which of the 16 Projects in the KeyStep Pro
internal memory will receive the User Project you have selected.
CAUTION: If you follow the procedure below, you will overwrite the current Project that resides inside
the KeyStep Pro. Be sure this is what you want to do! If not, please store it to another location inside the
KeyStep Pro.
For this example, we'll assume that Project Berlin1 is available:
1.
First, select 'Project Berlin1' in the list as shown above.
2.
Select the User Project you would like to store into the KeyStep Pro.
3.
Click the Store To button at the bottom of that section.
That's all there is to it! The settings and sequences of the User Project have been stored as
Project Berlin1 in the KeyStep Pro. Now you can load that Project whenever you want by
holding down the Project/Utility button and pressing the step 2 button.
130
Arturia - User Manual Keystep Pro - KeyStep Pro Configuration
Advertisement
Table of Contents
