Table of Contents
Advertisement
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
1
Installing the Tow Pole
Parts needed for this procedure:
1
Tow pole kit (sold separately)
Installing the Tow Pole to the
Machine
Note:
The tow pole is purchased separately and
includes the nut and bolt needed for installation.
The machine has the following tow pole options:
Hitch Type
50 mm (2 inch) ball—stamped
50 mm (2 inch) ball—forged
Pintle
1.
Remove the bolt and nut from the tow pole
(Figure
3).
Description
Tow pole kit (sold separately)
Safety chain
Connecting link
Length
127 cm (50 inches)
127 cm (50 inches)
127 cm (50 inches)
Qty.
1
Install the tow pole.
1
Install the safety chain.
2
1. Tow pole
2. Front post
3. Bolt
2.
Slide the tow pole forward and align the hole in
the pole with the hole in the frame fitting
3).
3.
Insert the bolt through the holes in the fitting and
the pole
(Figure
4.
Thread the nut onto the bolt and tighten them
until they are tight against the frame fitting
(Figure
3).
Note:
If the self-locking nylon insert in the
locknut wears with use, replace the nut with a
new Grade 5 or Grade 8 locknut.
9
Use
Figure 3
4. Bolt hole
5. Frame fitting
6. Nut
3).
g019804
(Figure
Advertisement
Table of Contents
