Toro CM-1258Y-SD Operator's Manual page 15

Concrete mixer
Hide thumbs Also See for CM-1258Y-SD:
Table of Contents

Advertisement

Drum-Tilt Brake
1. Unlocked position
4.
Ensure that the engine cowl is closed and
latched; refer to
5.
Inspect the tires and wheels; refer to
the Tires and Wheels (page
Checking the Tires and Wheels
Service Interval: Before each use or daily—Inspect
the tires and wheels.
After each use—Torque the lug nuts to 108 to
122 N-m (80 to 90 ft-lb) after towing.
WARNING
Failure to maintain correct tire pressure
may result in tire failure and loss of control,
resulting in property damage and serious
injury or death.
• Check the tire pressure frequently to
ensure proper inflation. If the tires are not
inflated to the correct pressure, they will
wear prematurely.
• Inspect the tire condition before towing
and after any operating accident.
The DOT tire information is located on the side of
each tire. This information gives load and speed
ratings. Replacement tires should have the same
or better ratings. For more information go to
http://www.nhtsa.gov/Vehicle+Safety/Tires.
Figure 11
2. Locked position
Closing the Cowl (page
Checking
15).
Note:
Refer to
that all replacement tires meet or exceed the ratings
for this machine.
1.
Visually inspect the tires for damage and wear
(Figure 12
1. Example of tire wear caused by underinflation
g019733
19).
1. Example of tire wear caused by overinflation
2.
Ensure that the tires are inflated to the correct
air-pressure. The following rating indicates the
appropriate air pressure for the tires as installed
at the factory.
Important:
the actual tires for the correct air pressure
requirement.
Important:
trouble is underinflation. Maintain full air
pressure.
Air Pressure: Max 241 kPa (35 psi)
3.
Ensure that the wheel lug nuts are torqued to
108 to 122 N-m (80 to 90 ft-lb).
Note:
initially and after towing.
Note:
shown in
15
Specifications (page 14)
and
Figure
13).
Figure 12
Figure 13
Always check the information on
The most common cause of tire
Check the torque of the wheel lug nuts
Torque the lug nuts in the sequence
Figure
14.
and ensure
g020836
g010293

Advertisement

Table of Contents
loading

Table of Contents