Setup; Installing The Dump Handle; Installing The Tow Pole - Toro MMX-650E-S Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
1

Installing the Dump Handle

Parts needed for this procedure:
1 Dump handle
2 Bolt
2 Nut
Installing the Dump Handle to the
Drum
1. Cut the cable ties to remove the dump handle
from the underside of the grate.
2. Position the dump handle so that the bolt holes
align with the bolt holes in the drum
Description
Dump handle
Bolt
Nut
Tow pole kit (sold separately)
Safety chain (sold with optional tow pole
kit)
Connecting link (sold with optional tow
pole kit)
No parts required
(Figure
Qty.
1
2
2
1
1
2
–
3).
3. Insert 1 carriage bolt into the square bolt hole
and slide the corresponding hole of the drum
handle over
4. Install a nut onto the bolt, and tighten it.
5. Repeat the previous steps for the remaining
carriage bolt.
8
Use
Install the dump handle.
Install the tow pole.
Install the safety chain.
Adjusting the mixing paddles.
Figure 3
it(Figure 3).
g028569