Table of Contents
Advertisement
Filling the Engine Crankcase with
Oil
1.
Remove the dipstick
oil into the fill hole until the oil is between the
upper and lower limit on the dipstick.
Figure 36
1. Dipstick upper limit
2. Dipstick lower limit
2.
Install and secure the dipstick.
3.
Wipe up any spilled oil.
(Figure
36) and slowly pour
3. Oil-filler port
Servicing the Engine-Oil
Filter
Service Interval: After the first 50 hours—Clean the
Every 400 hours—Clean the engine oil-filter.
Replace it if it is damaged.
Inspecting and Cleaning the
Engine-Oil Filter
1.
Remove the oil-filter retaining bolt.
2.
Pull the oil-filter cap out and remove the oil filter.
1. Oil filter
g019993
2. Oil-filter cap
3.
Clean the oil filter or replace it if it is damaged.
4.
Install the oil filter.
5.
Make sure that the oil-filter cap is fully seated.
6.
Install and tighten the oil-filter-retaining bolt.
7.
Add new engine oil; refer to
Crankcase with Oil (page
8.
Warm up the engine by running it for 5 minutes,
and check for any engine oil leaks.
9.
After the engine is warm, turn it off and let it sit
for 10 minutes.
10.
Check the engine oil level by fully inserting, but
not screwing in, the dipstick.
11.
Add engine oil as needed; refer to
Engine-Oil Level (page 22)
31
engine-oil filter. Replace it if it is
damaged.
Figure 37
3. Oil-filter retaining bolt
Filling the Engine
31).
Checking the
g020389
Advertisement
Table of Contents
