Toro CM-1258Y-SD Operator's Manual page 16

Hitching a Machine with a Stamped
Ball Coupler
1. Apply chassis grease to the socket of the coupler
and the area of the clamp that contacts the ball.
2. Oil the pivot points and sliding surfaces of the
coupler with SAE 30 motor oil.
3. Open the coupler latch
Figure 14
(Figure 15).
g021107
1. Bail
4. Position the coupler on top of the hitch ball
(Figure 15A).
5. Close the coupler latch
6. Open the bail on the safety pin and insert the pin
through the hole in the latch
7. Rotate the free end of the bail over the end of
the safety pin that is protruding through the latch
(Figure 15C).
8. If the machine is equipped with a trailer-light kit,
connect the wire plug of the tow vehicle to the
wire plug of the machine.
16
Figure 15
2. Safety pin
(Figure 15B).
(Figure 15B).
g020359