Advertisement
Quick Start Guide
Table 2-1: Performance Specifications (continued)
NO2
COM2
NC2
NO3
COM3
NC3
NO4
COM4
NC4
2.4.4
Sensor wiring to signal boards
Plug the pre-terminated sensor cable connector directly into the turbidity
signal board mating connector.
WARNING
Electrical shock
Electrical installation must be in accordance with the National Electrical
Code (ANSI/NFPA-70) and/or any other applicable national or local codes.
2.4.5
Wire sensor cable
The sensor cable is pre-wired to a plug that inserts into a receiving socket on
the signal board.
See
Figure
20
2-4.
Relay 2
Relay 3
Relay 4
Emerson.com/Rosemount
April 2020
Advertisement
