HySecurity HyNet Gateway SFP 4/1 Installation Manual
Strongarm m30, strongarm m50, hydrasupply xl, hydrawedge sm50
Hide thumbs
Also See for HyNet Gateway SFP 4/1:
- User manual (37 pages) ,
- Installation manual (8 pages) ,
- Installation manual (8 pages)
Advertisement
Quick Links
StrongArm M30, StrongArm M50,
HydraSupply XL, HydraWedge SM50
Installation Manual for HyNet Attachment Kit: MX3868
This document is a supplemental document that provides specific information regarding
configuration of the HySecurity gate operator with installation and wiring of the HyNet Gateway. For
safety considerations and information specific to your gate operator, refer to the HySecurity gate
operator's product manuals.
Advertisement
Related Manuals for HySecurity HyNet Gateway SFP 4/1
Summary of Contents for HySecurity HyNet Gateway SFP 4/1
- Page 1 This document is a supplemental document that provides specific information regarding configuration of the HySecurity gate operator with installation and wiring of the HyNet Gateway. For safety considerations and information specific to your gate operator, refer to the HySecurity gate...
-
Page 2: Led Indicators
Hardware functioning and coin battery charged. Red steady or no LED lit HyNet internal switch is not functioning. GREEN steady HyNet internal switch is functioning. Drawing is not to scale D0720 Rev. B HyNet Attachment Kit: MX3868 © 2019 www.hysecurity.com... -
Page 3: Tools Required
HySecurity CRASH Products and HyNet Assembly with Attachment Bracket DIN rail mounting screws DIN rail mount Attachment Bracket Star washers Bracket mounting screws Tools Required • Phillips head screwdriver HyNet Mounting Plate www.hysecurity.com © 2019 StrongArmCRASH, HydraWedge SM50, HydraSupply XL Installation... - Page 4 HyNet Assembly DIN Rail Mount Attachment bracket HyNet Installation on StrongArm M30 Control HyNet Panel Mounting plate Mount HyNet module onto DIN rail next to Power Disconnect Switch. D0720 Rev. B HyNet Attachment Kit: MX3868 © 2019 www.hysecurity.com...
- Page 5 HyNet Assembly shown attached to DIN rail in Pivot Post NOTE: The HydraSupply cabinet (not shown) contains a DIN rail and the HyNet is mounted similarly to it. www.hysecurity.com © 2019 StrongArmCRASH, HydraWedge SM50, HydraSupply XL Installation D0720 Rev. B...
- Page 6 DO NOT connect to +24V tabs at base of Smart Touch Controller. Only use the +24V CAUTION connections on the power supply terminal block. Drawing is not to scale. D0720 Rev. B HyNet Attachment Kit: MX3868 © 2019 www.hysecurity.com...
- Page 7 Smart Touch Controller HySecurity gate operators provide a 2-wire, serial interface (RS-485 connection) which allows remote access to one or more operators. When the physical connection is made and protocols are established, an SA (System Address) must be assigned for each operator through its Installer Menu.
- Page 8 • Communicate (verify) system address to IT Network Admin for proper web page configuration. 4. Review gate operator installation checklist from gate operator manual _____________ 5. Take photographs of installation and provide an End User Demo _____________ D0720 Rev. B HyNet Attachment Kit: MX3868 © 2019 www.hysecurity.com...