HySecurity HYNET GATEWAY SFP 4/1 Installation Manual
Hide thumbs
Also See for HYNET GATEWAY SFP 4/1:
- User manual (37 pages) ,
- Installation manual (8 pages) ,
- Installation manual (8 pages)
Advertisement
Quick Links
StrongArmPark DC 10 and StrongArmPark DCS 10
StrongArmPark DC 14 and StrongArmPark DCS 14
Installation Manual for HyNet Attachment: MX3867
This document is a supplemental document that provides specific information regarding
configuration of the HySecurity gate operator with installation and wiring of the HyNet Gateway.
For safety considerations and information specific to your gate operator, refer to the HySecurity
gate operator product manuals.
Advertisement
Related Manuals for HySecurity HYNET GATEWAY SFP 4/1
Summary of Contents for HySecurity HYNET GATEWAY SFP 4/1
- Page 1 Installation Manual for HyNet Attachment: MX3867 This document is a supplemental document that provides specific information regarding configuration of the HySecurity gate operator with installation and wiring of the HyNet Gateway. For safety considerations and information specific to your gate operator, refer to the HySecurity...
-
Page 2: Hynet Components
Hardware functioning and coin battery charged. Red steady or no LED lit HyNet internal switch is not functioning. GREEN steady HyNet internal switch is functioning. Drawing is not to scale D0719 Rev. C HyNet Attachment Kit: MX3867 © 2016 www.hysecurity.com... - Page 3 HyNet mounting plate applying Velcro adhesive backing. ® Velcro strip Peel off protective layer and adhere Velcro strip to HyNet mounting plate. ® Velcro strip ® Adhere to gate operator chassis. HyNet Assembly www.hysecurity.com © 2016 StrongArmPark DC Installation D0719 Rev. C...
- Page 4 Peel protective paper off the StrongArmPark DC chassis. Press firmly. Velcro strip. ® NOTE: Recommended HyNet location is shown in the illustration. Ambient temperature for adhesion is between 45˚ and 85˚ F. D0719 Rev. C HyNet Attachment Kit: MX3867 © 2016 www.hysecurity.com...
- Page 5 On controllers with part numbers marked MX001457 and MX3037 Revisions A, B, and C, Drawing is not to scale. be sure you're connecting the flying lead to the +24V spade located under RADIO OPTIONS. www.hysecurity.com © 2016 StrongArmPark DC Installation D0719 Rev. C...
- Page 6 Smart DC Controller HySecurity gate operators provide a 2-wire, serial interface (RS-485 connection) which allows remote access to one or more operators. When the physical connection is made and protocols are established, an SA (System Address) must be assigned for each operator through its Installer Menu.
- Page 7 • Communicate (verify) system address to IT Network Admin for proper web page configuration. 4. Review gate operator installation checklist from gate operator manual _____________ 5. Take photographs of installation and provide an End User Demo _____________ www.hysecurity.com © 2016 StrongArmPark DC Installation D0719 Rev. C...
- Page 8 D0719 Rev. C HyNet Attachment Kit: MX3867 © 2016 www.hysecurity.com...