Lewmar V8 Owners Installation, Operation & Servicing Manual page 21

6.8 All Models fitting/replacing gypsy
1. Unscrew shoulder screw and unwind top cap anti-clockwise until loose.
2. Lift off drum, unscrew chain cover bolts and remove.
3. Prize loose the spiral spring clip on centre stem and remove with the tab washer.
4. Place gypsy with bearing over centre stem ensuring engagement with band brake. Assemble in reverse
order. Wind down drum until the dog drive lugs are clear of the gypsy lugs by 2 mm. Apply Loctite®
threadlock to M6 screw and screw down until it stops. Drum can then be wound down fully.
NOTE: Ensure spiral spring clip is in groove when reassembling.
⚠ WARNING! Isolate the windlass
using circuit breaker/isolator.
7.3-1
7.3-3
Lewmar V8/V9/V10/V12 Vertical Windlass ref 66300094 Iss.6
7.3-2
7.3-
4
2 mm
|
21