Table of Contents
Advertisement
3 - Preparation
Inserting and removing SD card
Inserting SD card
Insert an SD card into an SD card slot on the front of the unit to
enable it to record.
NOTE
SD cards can be inserted whether or not the unit is on or off.
o Inserted SD card with the correct orientation.
o The label should be up and the connector should be inserted
toward the back.
Removing SD card
After selecting the SD card on the Storage Device Management
screen and pressing the
(see "Advanced page" on page 22)
ATTENTION
Never remove an SD card when data is being written. Doing
so could cause data to be lost.
1.
Press the SD card in gently to make it to come forward.
2.
Pull the SD card out by hand.
8
TASCAM VS-R264 / VS-R265
button, remove the SD card.
SD card write protection
SD cards have write-protection switches that prevent writing
new data to them.
If you slide the protection switch to the "LOCK" position,
recording will not be possible. Unlock cards to enable recording.
Connecting and disconnecting USB
storage
Connecting USB storage
Connect USB storage to the USB port on the back of the unit to
enable recording.
NOTE
You can connect USB storage when the unit is on or off.
Disconnecting USB storage
After selecting the USB storage device on the Storage Device
Management screen and pressing the
the USB storage device. (see "Advanced page" on page 22)
ATTENTION
Never disconnect USB storage when data is being written.
Doing so could cause data to be lost.
button, remove
Advertisement
Table of Contents
