Encoder Control Page - Tascam VS-R264 Reference Manual

Encoder Control page

All the encoder functions of VS-R264 and VS-R265 units on
the current network can be controlled on the Encoder Control
screen.
The name of the current device is shown in the first line of the
table.
Every line shows the status of encoder functions and has
buttons to change their settings.
1 Device Name
This shows the name set in the Name item on the General
page of the Device Settings screen. (see "General page" on
page 20)
2 Analog Overload
These light when input signals reach 3 dB below the
maximum input level.
3 Input Resolution
This shows whether a valid video signal is detected for the
selected video source.
i This column shows the resolution and frame rate when
a valid video signal is detected from the selected video
source.
i When is shown, no valid video signal is currently being
detected.
A pop-up message will appear if the mouse pointer is placed
over the icon.
4 Streaming
This shows whether the encoder is actively streaming.
A pop-up message will appear if the mouse pointer is placed
over the icon.
Indicator
Pop-up message Meaning
appearance
Streaming
Not streaming
RTMP connecting
Initializing
Error connecting
to RTMP server
4 - Using Streaming Dashboard
Streaming is active
(RTMP, HLS, unicast,
multicast or RTSP).
All streaming is off.
RTMP is connecting to a
server.
The HLS server is
initializing.
An error occurred
during connection.
Confirm that the correct
values have been input
for the RTMP settings.
Indicator
Pop-up message Meaning
appearance
Waiting for input
Unable to encode
5 Recording
This shows whether the video signal is being recorded to the
selected external storage.
A pop-up message will appear if the mouse pointer is placed
over the icon.
Indicator
Pop-up message
appearance
Recording
Not recording
Finishing FTP
Uploads. 1 file(s)
remaining...
Storage device
unmounting
Waiting for input
Waiting for
storage device
Storage device
unmounted,
please re-insert
Storage device full
Storage device is
too slow. Try using
a faster device
or lowering the
video bitrate
FTP login failure
FTP server storage
full
TASCAM VS-R264 / VS-R265
The encoder is waiting
for video signal input.
Confirm that the video
source power is on and
a video signal is being
output.
The encoder has
detected video signal
input, but its format is
not supported.
Meaning
The signal is being
recorded to the
selected storage.
Recording is off.
Recorded files are
being uploaded.
The storage is being
unmounted.
Wait until unmounting
completes before
disconnecting storage.
Input a valid HDMI
source and start
recording.
Connect storage and
start recording.
The storage is not
mounted.
Reconnect it.
The storage is full.
Increase the available
open space on the
storage.
Data transfer to the
storage device is not
fast enough. Switch to
a faster storage device
or reduce the video
transfer rate.
The user name/
password provided for
the FTP server is invalid.
The FTP server is full.
Increase the available
open space on the
server.
11