Table of Contents
Advertisement
Multicast page
Make settings to stream to a multicast address on this page.
Multicast Output
Click this area to turn output to the multicast address on/off
(default: Off ).
Follow these procedures to set the output to a multicast
address.
1.
Select the protocol.
Select "rtp://" to increase reliability or "udp://" to decrease
waiting time.
NOTE
Each encoder must be set with a unique valid combination of
multicast address and port number.
2.
Input the multicast address.
Range: 224.0.0.1 - 239.255.255.255
3.
Input the port number to set the network port for
transmitting the multicast stream.
Range: 1024 - 49150
4.
Set the TTL (Time to Live) .
The recommended TTL value is "5".
4 - Using Streaming Dashboard
Unicast 1/2 pages
Make settings to stream to a unicast address on this page.
In addition to streaming to a multicast address, this unit can
simultaneously stream to two unicast addresses.
Settings can be made separately for each unicast address.
Unicast Output 1/2
Click this area to turn output to the unicast address on/off
(default: Off ).
NOTE
When streaming between two VS-R264/VS-R265 units, make
streaming settings on the Decoder Stream Settings screen.
(see "Decoder Stream Settings screen settings" on page 18)
Set this when outputting to a third-party decoder device.
Follow these procedures to set the output to a unicast address.
1.
Select the protocol.
Select "rtp://" to increase reliability or "udp://" to decrease
waiting time.
2.
Manually input the IP address of the third-party decoder
device. (see "If a unit cannot be found using TASCAM
DISCOVERY" on page 10)
3.
Manually input the port number of the third-party decoder
device. Set up the decoder device to receive on the same
port number.
15
TASCAM VS-R264 / VS-R265
Advertisement
Table of Contents
