Decoder Stream Settings - Tascam VS-R264 Reference Manual

Decoder stream settings

Decoder stream settings according to source
type differences
Decoder stream settings differ according to the source type
being used.
The following explains the necessary settings for decoding
multicast and unicast streams from this unit and third-party
encoder devices.
TASCAM Source, Multicast
o Source Encoder
Select the VS-R264/VS-R265 outputting the stream.
o Stream Type
Select "Multicast".
o Multicast Protocol
This shows the protocol set by the encoder.
o Multicast IP Address
This shows the IP address set by the encoder.
o Multicast Port
This shows the port number set by the encoder.
NOTE
Set the Multicast Output switch to "On" on the Multicast page
of the Output Settings screen to enable multicast output for
this unit. (see "Output Settings screen settings" on page 14)
TASCAM Source, Unicast
o Source Encoder
Select the VS-R264/VS-R265 outputting the stream.
o Stream Type
Select "Unicast".
o Protocol
Select the protocol to use.
o Port
Select the port number to use for receiving stream output
encoded by the VS-R264/VS-R265.
The recommended port numbers are even numbers from
1024 - 49150.
TASCAM Source, HLS
o Source Encoder
Select the VS-R264/VS-R265 outputting the stream.
o Stream Type
Select "HLS".
o URL
This shows the URL set by the encoder.
Third Party Source, Multicast
Set the third-party encoder device to output video data
compressed as H.264 or H.265 (VS-R265 only) on an MPEG-
2 transport stream using RTP over UDP (rtp://) or Raw UDP
(udp://).
Encode the audio in the stream as AAC.
Set the RTP multicast IP address and port number in the third-
party encoder device.
Always use a valid multicast IP address.
4 - Using Streaming Dashboard
The recommended values are from 239.0.0.0 - 239.255.255.249.
o Source Encoder
Select "Other Encoder".
o Stream Type
Select "Multicast".
o Multicast Protocol
Select the protocol suitable for the video source.
o Multicast IP Address
Input the IP address of the currently set video source.
Check the third-party encoder device for the currently set
IP address.
o Multicast Port
Input the port number of the currently set video source.
Check the third-party encoder device for the currently set
port number.
Third Party Source, Unicast
Set the third-party encoder device to output video data
compressed as H.264 or H.265 (VS-R265 only) on an MPEG-
2 transport stream using RTP over UDP (rtp://) or Raw UDP
(udp://).
Encode the audio in the stream as AAC.
o Source Encoder
Select "Other Encoder".
o Stream Type
Select "Unicast".
o Protocol
Select the protocol suitable for the video source.
o Port
Input the currently set unicast port number. Check the
third-party encoder device for this information.
Third Party Source, RTMP
Follow these procedures to set up the target decoder to receive
the RTMP playback type from the streaming server.
The RTMP streaming server must be streaming with H.264 video
and AAC audio codecs.
o Source Encoder
Select "Other Encoder".
o Stream Type
Select "RTMP".
o URL Prefix
Confirm that "rtmp://" or "rtmps://" is selected.
o URL
Input the RTMP source URL.
Third Party Source, HLS
o Source Encoder
Select "Other Encoder".
o Stream Type
Select "HLS".
o URL
Input the HLS source URL.
19
TASCAM VS-R264 / VS-R265