Table of Contents
Advertisement
1.
2.
3.
4.
2.3.3
Mounting the Device to a Panel
For panel installations, the RUGGEDCOM RS400F can be equipped with panel/DIN rail
adapters pre-installed on each side of the chassis. The adapters allow the device to
be attached to a panel using screws.
RUGGEDCOM RS400F
Installation Manual, 02/2020, C79000-G8976-1341-04
Make sure the rack mount adapters are installed on the correct side of the chas-
sis.
Note
The chassis features multiple mounting holes, allowing the rack mount adapters
to be installed up to 25 mm (1 in) from the face of the device.
1
Rear
1
Front
2
Rack Mount Adaptor
3
Figure 2.3
Rack Mount Adaptors
If required, install adapters on the opposite side of the device to protect from vi-
brations.
Insert the device into the rack.
Note
Since heat within the device is channelled to the enclosure, it is recommended
that 1 rack-unit of space, or 44 mm (1.75 in), be kept empty above the device.
This allows a small amount of convectional airflow.
Forced airflow is not required. However, any increase in airflow will result in a
reduction of ambient temperature and improve the long-term reliability of all
equipment mounted in the rack space.
Secure the adapters to the rack using the supplied hardware.
Installing the Device
2.3.3 Mounting the Device to a Panel
1
11
Advertisement
Table of Contents
