Required Tools And Materials - Siemens SIMATIC NET RUGGEDCOM RS400F Installation Manual

Introduction
1.3 Required Tools and Materials
Ethernet Port Status LEDs
Communication Ports
RS-232 Console Port
Failsafe Alarm Relay
Power Supply Terminal Block
1.3

Required Tools and Materials

The following tools and materials are required to install the RUGGEDCOM RS400F:
AC or DC power cord (16 AWG)
Multi-mode and/or single-mode fiber optic cables
CAT-5 Ethernet cables
Flathead screwdriver
Phillips screwdriver
4 x #6-32 screws
4
Indicate the status of the associated serial port.
Receive and transmit data, as well as provide access to the RUGGED-
COM RS400F Web interface. For more information about the vari-
ous ports available for the RUGGEDCOM RS400F, refer to
nication Ports (Page
The serial console port is for interfacing directly with the device and
accessing initial management functions. For information about con-
necting to the device via the serial console port, refer to
ing to the Device (Page
Latches to default state when a power disruption or other alarm
condition occurs. For more information, refer to:
• "Connecting the Failsafe Alarm Relay (Page 12)"
• "Failsafe Alarm Relay Specifications (Page 27)"
A pluggable terminal block. For more information, refer to
necting Power (Page 13)"
(Page 27)"
Tools/Materials
LED State
Rx Blinking
Off
Tx Blinking
Off
LED State
RxX Blinking
Off
Tx Blinking
Off
19)".
17)".
and "Power Supply Specifications
For connecting power to the device.
For connecting the device to a LAN.
For connecting the device to a LAN.
For mounting the device to a DIN rail.
For mounting the device to a panel.
For mounting the device to a panel.
Installation Manual, 02/2020, C79000-G8976-1341-04
Meaning
Link activi-
ty (receive)
No link activity
Link activi-
ty (transmit)
No link activity
Meaning
Link activi-
ty (receive)
No link activity
Link activi-
ty (transmit)
No link activity
"Commu-
"Connect-
"Con-
Purpose
RUGGEDCOM RS400F