Connecting Network Cable To The Ga-1120; Back View Of The Ga-1120; Ethernet Connection - Toshiba GA-1120 Configuration Manual

1
1-10 Connecting to the Network
RJ-45 Ethernet (10/100Base T)
Not used
T
O CONNECT TO THE
•

Connecting network cable to the GA-1120

In this section, the back panel of the GA-1120 is illustrated, followed by information
for connecting to the Ethernet board.

Back view of the GA-1120

Illustration TBD

Ethernet connection

For Ethernet connections, the GA-1120 supports Unshielded Twisted Pair (UTP)
cabling, defined as Category 5 for use with 100BaseT; or as Category 3, Category 4, or
Category 5 for use with 10BaseT. The cable uses an 8-pin RJ-45 connector that plugs
into the RJ-45 socket on the GA-1120.
The 100BaseT type supported by the GA-1120 is 100BaseTX, also known as
N :
OTE
Fast Ethernet. If an Ethernet hub is used, it must be a 100BaseTX hub. The term
"100BaseT" is used to refer to 100BaseTX.
E
THERNET BOARD
Connect the network cable to the RJ-45 connector on the back of the GA-1120.
You must use a Category 5 unshielded twisted pair cable network cable for 100BaseT.