Toshiba GA-1120 Configuration Manual page 68

4
4-16 Performing Setup from the Control Panel
AppleTalk Zone
List of zones
The GA-1120 searches the network for AppleTalk zones in your network segment.
Scroll through the list to select the AppleTalk zone in which you want the GA-1120 to
appear. If your segment has only one zone, the GA-1120 is assigned to that zone
automatically.
The message "No AppleTalk zone found" may mean your network has no zones, or the
network cable is not connected (see
TCP/IP Setup options
To configure the GA-1120 for TCP/IP, choose TCP/IP Setup.
Choose Ethernet Setup and enter the appropriate settings. Choose each network
type you use (Ethernet) and enter the appropriate settings.
When you set an IP address, subnet mask, or gateway address for the GA-1120 during
Setup, you can allow the GA-1120 to get these addresses automatically from a DHCP,
BOOTP, or RARP server. First, turn on or restart the GA-1120 and allow it to reach
Idle. Next, make sure the DHCP, BOOTP, or RARP server is running. Finally,
perform GA-1120 Setup.
Appendix A). Choose Set to dismiss the message.