Table of Contents
Advertisement
Installation
Mount the BACnet Thermostat on an interior wall in the room to be controlled. Locate it where the occupant can easily read
the LCD display and use the controls. If the built-in temperature sensor is being used to measure room temperature, place
the thermostat where the temperature is representative of the general room conditions. Avoid cold or warm air drafts,
radiant heat, and direct sunlight.
WARNING: Risk of electric shock and property damage. Disconnect power supply before making electrical
connections. The installation is to be performed by a qualified electrician.
WARNING: The integrated circuits in the controller are sensitive to static currents. Take suitable
precautions.
General
Installation procedure
Prerequisite: Disconnect power to the main board before installing the unit.
1
Separate the front display from the back plastic cover by inserting a small flat screwdriver into each of the
three slots and rotating it gently. See picture below.
2
Remove the front display and keep it in a safe place.
3
Connect wires as shown on the wiring diagram. All terminals accept 1x0.5mm
4
Set DIP switch positions as explained in this manual.
5
Place the thermostat in the electrical box and tighten the 2 screws.
Europe - Gewiss Box - GW 24 203 or similar
US - Carlon – B114R or similar
6
Reattach the front display to the back cover by pushing it towards the wall.
ComfortVu™ BACnet Thermostat Plus Model TBPL-H (Line voltage)Carrier Proprietary and Confidential
Installation and Operation Guide
21
2
/24 AWG.
CARRIER CORPORATION ©2020
All rights reserved
Advertisement
Table of Contents
