Operation; Switching On The Generator - Fischer Panda xControl Series Manual

Panda xControl

2.3 Operation

The xControl is operated by means of the xControl CP-G panel.
Fig. 2.3-1: xControl CP-G front

2.3.1 Switching on the generator

Press the "ON/OFF" switch to switch on the control
Fig. 2.3.1-1: Switching on the generator
system of the generator.
The xControl Generator thereby switches to "standby mode".
If automatic starting is activated at the menu, the
generator can henceforth be started by means of an
external signal.
The CP-G Panel displays the home page for two seconds.
Fig. 2.3.1-2: Home Page
The CP-G then displays the address page for one second
Fig. 2.3.1-3: Address Page
29.9.16 Chapter 2: Panda xControl - Page 9