How To Set The Panel Language After A Reset; Faults; Symbols And Messages On The Display; Example Of Message - "Sensor Defective - Fischer Panda xControl Series Manual

Panda xControl

2.5.4.1 How to set the panel language after a reset.

1. Switching on the xControl Panel CP-G
2. Wait until the first overview screen appears.
3. Scroll to the last overview screen.
4. Press the "Start/Stop - Enter" key to access the menu.
5. Scroll down to the "Panel" menu item.
6. Press the "Start/Stop - Enter" key to access the "Panel" sub-menu.
7. Scroll down to the "Choose language" menu item.
8. Press the Start/Stop - Enter key to access the "Language Selection" sub-menu.
9. Scroll to the desired language and confirm with the "Start/Stop - Enter" key.
10.Scroll down to the "Confirm" menu item and press the "Start/Stop - Enter" key.
The menu text is now set to the selected language.

2.6 Faults

2.6.1 Symbols and messages on the display

2.6.1.1 Example of message - "Sensor defective"

A soon as a defective sensor is detected, the xControl
Fig. 2.6.1.1-1: Sensor defective
reports this on the display.

2.6.1.2 Example of message - "Sensor/Cable break"

If the sensor has failed or the cable is broken, the
Fig. 2.6.1.2-1: Sensor/Cable break
following report is displayed:

2.6.2 Error code

An error code is displayed if a parameter lies beyond its operating limits.
See "Table of Faults" on page 26. See "Description of the symbols" on page 27.
Example: Error No. 7 - Oil pressure too low -Fault led to emergency shutdown
29.9.16 Chapter 2: Panda xControl - Page 25