Panda Xcontrol; Components Of The Xcontrol; Xcontrol - Cp-G; Xcontrol - Gc-S - Fischer Panda xControl Series Manual

Panda xControl

2. Panda xControl
The Panda xControl is a generator control system with three main components.

2.1 Components of the xControl

2.1.1 xControl - CP-G

(Control Panel – Generator) - Part No. 21.02.02.204P
Display and Control Element of the xControl
The xControl CP-G is the display and control element
Power is supplied via the bus cable. Multiple control
elements can be installed in a single system.

2.1.2 xControl - GC-S

(Generator Control - Servo) - Part.No. 21.02.08.019P
Main module of the xControl.
The module contains the control electronics
The xControl GC-S is usually installed in the generator
capsule.
The xControl GC-S takes over the monitoring and control of
the diesel engine of the Fischer Panda generator, as well as
the control of the output voltage and frequency of the
generator.
The xControl GC-S is suitable for 12V and 24 V starting systems. The connected actuators are supplied with power
via switching outputs with input voltage.
Current measurement is single-phase and can be done directly.
measurement takes place via an external current sensor. An additional three-phase module can be used for three-
phase generators.

2.1.3 xControl - CB-G

(Connection Box - Generator)
The xControl GC-S is usually installed in the generator
capsule (externally).
The xControl CB-G is the external terminal block for the
xControl generator.
The control element and the fuel pump are connected here.
29.9.16
Fig. 2.1.1-1: Control Panel - Generator
Fig. 2.1.2-1: Generator Control - Servo
A voltage sensor is not necessary.
Fig. 2.1.3-1: Connection Box - Generator
Chapter 2: Panda xControl - Page 7
Current