Sub-Menu: "Panel; Setting The Illumination Of The Cp-G - Fischer Panda xControl Series Manual

Panda xControl

2.5.2 Sub-menu: "Panel"

The following items can be selected in the Panel sub-
menu:
1. Lighting
- changes the brightness of the display in normal mode.
2. Contrast
- changes the contrast of the display.
3. Standby Time
- to set the time until the panel switches to standby mode.
4. Standby Lighting
- changes the brightness of the display in standby mode.
5. Display Mode
- changes the display mode of the overview pages.
6. Language selection
- changes the language of the panel
7. Temperature Unit
- to set the temperature unit to °C or °F
8. Audible alarm
- to activate the audible alarm in the event of a fault
9. Flashing when faulty
- to activate panel flashing in the event of a fault
10.Panel heating
- activates panel heating at temperatures <+10°C
11. Reset to standard
The "Panel" sub-menu
12.is reset to the factory settings
- Switching from the "Panel" sub-menu to the Main Menu

2.5.2.1 Setting the illumination of the CP-G

The menu item is selected by using the "Step-up"/"Step-down" keys confirmed with the "Start/Stop - Enter" key. The
respective menu item opens.
29.9.16
Fig. 2.5.2-1: Sub-menu: Panel
Chapter 2: Panda xControl - Page 17