Overview Page With Autostart Activated; The Overview - Fischer Panda xControl Series Manual

Panda xControl
At the end of the power-on routine, the CP-G displays the
Fig. 2.3.1-4: Overview Page 1
first overview page.
The language as well as the display mode can be set in the
menu.
Overview Page 1 is the same in all display modes/languages.

2.3.1.1 Overview page with Autostart activated

Deadly danger! - The generator can be equipped with an WARNING: Autostart
Autostart function. This means that the generator is
started by an external signal. In order to prevent an
inadvertent start-up, the starter battery must be
disconnected before work on the generator may
commence.
The "Autostart" also remains active if the xControl CP-G
is switched off and then on again.
If a fault should arise when the generator is started or is
already operating, it is stopped and the Autostart is set to
"off".
If the generator is operated by Autostart and is stopped
manually, the Autostart is set to "off".
Once the system has been switched off and then on again,
the Autostart is active once more.
The first overview page shows if the Autostart is active.
Fig. 2.3.1-1: Overview Page 1 with Autostart
Overview Page 1 with Autostart function activated.
2.3.2 The overview pages
The display mode/language of the display can be set in the menu.
Page 10 - Chapter 2: Panda xControl 29.9.16