Starting The Generator - Fischer Panda xControl Series Manual

2.4.3 Starting up the generator
Deadly danger! - The generator can be equipped with an
Autostart function. This means that the generator is
started by an external signal. In order to prevent an
inadvertent start-up, the starter battery must be
disconnected before work on the generator may
commence.
1. Switch on the xControl CP-G
The remote control panel is started by pressing the On/Off
button. The On/Off button must be pressed until the Home
page is displayed.
2. Press the Start/Stop - Enter key
3. The xControl performs a self-test.
4. The xControl preheats the diesel engine.
After preheating, the generator is started by the xControl
system.
5. Starter on.
In order to minimise current consumption, preheating is
interrupted briefly when the starter is operated.
Page 14 - Chapter 2: Panda xControl
WARNING: Automatic start-up
Fig. 2.4.3-1: Switch on the panel
Fig. 2.4.3-2: Start the generator.
Fig. 2.4.3-3: Self-test
Fig. 2.4.3-4: Preheating
Fig. 2.4.3-5: Electric starter
Panda xControl
29.9.16