Smith & Noble Metro Track Round Wood Hardware Step By Step Installation Instructions

Ceiling mount single rod set

Advertisement

Quick Links

STEP BY STEP INSTALLATION INSTRUCTIONS
Metro Track Round
Wood Hardware
Ceiling Mount
Single Rod Set

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Metro Track Round Wood Hardware and is the answer not in the manual?

Questions and answers

Summary of Contents for Smith & Noble Metro Track Round Wood Hardware

  • Page 1 STEP BY STEP INSTALLATION INSTRUCTIONS Metro Track Round Wood Hardware Ceiling Mount Single Rod Set...
  • Page 2: Table Of Contents

    Everything Table of Contents You Need Getting Started ........3 Step 1 - Overview - Ceiling Mount Single Rod Set .
  • Page 3: Step 1 - Getting Started

    STEP 1 - GETTING STARTED OVERVIEW Metro Track Round Wood Ceiling Mount Single Rod Tools & Parts Before you begin, check the accompanying diagram to make sure you have all the parts you need. You’ll need to make sure the surface you intend to install your hardware is sturdy enough MOUNTING to accommodate the brackets.
  • Page 4: Step 3 - Attaching The Rod Connector

    STEP 2 - MOUNTING THE BRACKET STEP 3 - ATTACHING THE ROD CONNECTOR Place the panel on the rod. Hold it up Depending on your order, you may to the spot you wish to install it making have received a rod connector. sure there is enough spacing from wall to where the back of drapery will hit.
  • Page 5: Step 4 - Placing Carriers & End Stops

    STEP 4 - PLACING CARRIERS & END STOPS STEP 5 - ATTACHING THE BRACKET TO THE ROD Adding or Removing Slide in the ceiling bracket cradle into Carriers to the Rod the rod. Do not tighten at this time. Your track rod will come with all master CARRIERS carriers and regular carriers pre- Attach End Cap Finial.
  • Page 6: Step 6 - Attach Finials

    STEP 6 - ATTACH FINIALS STEP 7 - ATTACHING BRACKETS TO THE CEILING Slide in End Cap onto rod and Hold the rod up and attach the bracket to the ceiling, aligning the holes of the tighten set screw. CEILING END CAP FINIALS BRACKET bracket with the marks you made on...
  • Page 7: Step 8 - Attaching Drapery To Rod

    STEP 8 - ATTACHING DRAPERY TO ROD ACCESSORIES Insert drapery pin hooks into carriers Baton/Wand (optional) and master carriers. CLIP Split Drapery Baton/Wand will be pre-attached to the master carrier(s). For Split drapery, start pinning from the center and go towards the ends. BATON/ WAND MASTER...
  • Page 8: Care & Cleaning

    CARE & CLEANING NOTES Minimal care and cleaning is needed to maintain the beauty of your Hardware. To Vacuum: Use brush or dust head attachment. To Dust: Use soft, clean cloth. smithandnoble.com 800.248.8888...
  • Page 9: Warranty

    Warranty Service The enjoyment of your hardware should be everlasting, which is why our products come with a limited lifetime warranty. The warranty applies to the original owner, requires a proof of purchase (hang on to your receipt!) and covers defects in material or craftsmanship. Hardware must have been properly installed.

Table of Contents