Summary of Contents for Smith & Noble Metro Track Flat Wood Hardware
Page 1
STEP BY STEP INSTALLATION INSTRUCTIONS Metro Track Flat Wood Hardware Warranty Service The enjoyment of your hardware should be everlasting, which is why our products come with a limited lifetime warranty. The warranty applies to the original owner, requires a proof of purchase (hang on to your receipt!) and covers defects in material or craftsmanship.
STEP 1 - GETTING STARTED OVERVIEW Tools & Parts Ceiling Mount Double Return Rod Set Before you begin, check the accompanying diagram to make sure you have all the parts you need. You’ll need to make sure the surface you intend to install your hardware is sturdy enough to accommodate the brackets.
STEP 2 - MARKING BRACKET PLACEMENT STEP 2 - MARKING BRACKET PLACEMENT 2 1/2" Mounting the Brackets Mounting the Brackets CLEARANCE FROM WALL Place the panel on the rod. To OR WINDOW have a spliced rod, mark where ensure it drapes at the correct that splice is on the wall since you length, hold it up to the spot you will need to add the special splice...
STEP 3 - ATTACHING THE ROD CONNECTOR STEP 4 - ADDING OR REMOVING CARRIERS Front Rod CARRIERS Depending on your order, you may Your track rod will come with all master ROD CONNECTOR have received a rod connector. carriers and regular carriers pre-installed. If you need to add or take out some A rod connector is the short piece of END STOP...
Page 6
STEP 4 - ADDING OR REMOVING CARRIERS STEP 4 - ADDING OR REMOVING CARRIERS Back Rod Back Rod CORNER CORNER FINIAL FINIAL CORNER SPLIT DRAPERY (A) Your track rod will come with all master FINIAL END STOP BACK CARRIERS carriers and regular carriers pre-installed. Once all carriers have been placed in the If you need to add or take out some track, for split drapery, place end stop in...
STEP 5 - ATTACHING BRACKET TO FRONT ROD STEP 6 - ATTACHING RETURN Insert the ceiling brackets into the Slide in return into front rod and channel in the back of the track. Do tighten set screw. not tighten at this time. MOUNTING CHANNEL CEILING...
STEP 7 - ATTACHING BRACKET TO CEILING STEP 8 - ATTACHING BACK ROD TO CEILING BRACKET Back Rod Place the front lip of the rod into the front edge of the clip. Attach the ceiling bracket to the ceiling, Rotate the back of the rod up into the clips aligning the holes of the bracket with and snap into place.
STEP 9 - ATTACHING FRONT ROD STEP 10 - ATTACHING DRAPERY TO ROD Insert drapery pin hooks into carriers Front Rod and master carriers. Split Drapery Hold the rod up and attach the bracket MASTER DRAPERY For Split drapery, start pinning from to the ceiling, aligning the holes of the CARRIER PINS...
ACCESSORIES CARE & CLEANING Baton/Wand (optional) Minimal care and cleaning is needed to maintain the beauty of your Hardware. Baton/Wand will be pre-attached to To Vacuum: Use brush or dust head attachment. the master carrier(s). To Dust: Use soft, clean cloth. CLIP BATON/ WAND...
Need help?
Do you have a question about the Metro Track Flat Wood Hardware and is the answer not in the manual?
Questions and answers