Related Manuals for Smith & Noble Euro Track Basics Hardware - Heavy Duty
Summary of Contents for Smith & Noble Euro Track Basics Hardware - Heavy Duty
- Page 1 STEP BY STEP INSTALLATION INSTRUCTIONS Euro Track Basics Hardware - Heavy Duty Wall Mount Double Rod Set...
-
Page 2: Table Of Contents
Everything Table of Contents You Need Getting Started ........3 Step 1 - Overview - Wall Mount Double Rod Set . -
Page 3: Step 1 - Getting Started
STEP 1 - GETTING STARTED OVERVIEW Tools & Parts Euro Track Basics Heavy Duty Wall Mount Double Rod Set Before you begin, check the accompanying diagram to make sure you have all the parts you need. You’ll need to make sure the surface you intend to install your hardware is sturdy enough to accommodate the brackets. -
Page 4: Step 2 - Mounting The Brackets
STEP 2 - MOUNTING BRACKETS STEP 2 - MOUNTING BRACKETS Place the panel on the rod. To ensure FIGURE A Place center of bracket cover plate it drapes at the correct length, hold level against wall at the marked spots. it up to the spot you wish to install Using a pencil, lightly draw a circle it;... -
Page 5: Step 3 - Attaching The Rod Connector
STEP 3 - ATTACHING THE ROD CONNECTOR STEP 4 - ADDING OR REMOVING CARRIERS Front Rod Depending on your order, you may BACK FRONT FIGURE A CARRIERS ONLY OR BACK CARRIERS have received a rod connector. Your track rod will come with all master carriers and regular carriers pre- A rod connector is the short piece of CONNECTOR... - Page 6 STEP 4 - ADDING OR REMOVING CARRIERS STEP 4 - ADDING OR REMOVING CARRIERS CARRIERS FRONT FRONT ROD FINIAL Back Rod Back Rod SPLIT DRAPERY (A) Your track rod will come with all FRONT ROD master carriers and regular carriers A Split Draw Once all carriers have been placed in FINIAL...
-
Page 7: Step 5 - Attaching Bracket Posts
STEP 5 - ATTACHING BRACKET POSTS STEP 6 - ATTACHING FINIALS (OPTIONAL) Insert the mounting posts into the Slide in End Cap onto rod and tighten END CAP FINIALS channel in the back of the track. screw. Do not tighten at this time. Attach End Cap Finial. -
Page 8: Step 7 - Attaching Back Rod Clips
STEP 7 - ATTACHING BRACKET POSTS TO BRACKET BASES STEP 8 - ATTACHING BACK ROD CLIPS 1. Assemble Back Rod Clips for Align the mounting posts in the back of Outside Posts. the track with the brackets mounted to the wall. Slide the mounting posts onto the brackets but don’t tighten. -
Page 9: Step 9 - Attaching Back Rod
STEP 9 - ATTACHING BACK ROD STEP 10 - ATTACHING DRAPERY TO ROD Place the front lip of the track into the Insert drapery pin hooks into carriers front edge of the clip. and master carriers. Split Drapery SPLIT DRAPERY Rotate the back of the track up into the For Split drapery, start pinning from clips and snap... -
Page 10: Care & Cleaning
ACCESSORIES CARE & CLEANING Baton/Wand (optional) Minimal care and cleaning is needed to maintain the beauty of your Hardware. Baton/Wand will be pre-attached to To Vacuum: Use brush or dust head attachment. the master carrier(s). To Dust: Use soft, clean cloth. CLIP BATON/ MASTER CARRIER... -
Page 11: Warranty
Warranty Service The enjoyment of your hardware should be everlasting, which is why our products come with a limited lifetime warranty. The warranty applies to the original owner, requires a proof of purchase (hang on to your receipt!) and covers defects in material or craftsmanship. Hardware must have been properly installed.