Table of Contents
Advertisement
Clearing the password
The password can be cleared from the system by entering
the "Clear Password" function.
This will clear the password stored in the system
Lathe Settings
The lathe setting will contain the toggles for the following
functions:
1. Assisted Brake
2. E-Stop Brake
3. Idle Stopping Function
4. Vibration Sensor
5. Factory Reset
Press the speed dial when the cursor is in line with the
desired option to toggle between the ON and OFF states of
each function.
Below table shows the function and the available states of the function:
Function Name
Assisted Braking
E-Stop Brake
Idle Stopping Function
Vibration Sensor
Factory Reset
Available States
ON/OFF
ON/OFF
ON/OFF
OFF/LOW/MED/HIGH
This option will commence the factory reset to restore all default lathe value.
30
128-1019-004
Description
The assisted braking function engages
the motor electronic brakes when the
<OFF> button is pressed while the
lathe motor is running to bring the
motor to a complete stop.
When the function is turned on, this will
engage the motor electronic brakes
when the Emergency Stop switch is
pressed while the lathe motor is
running.
When enabled, this function will
automatically turn the lathe motor off
when it detects the motor idling (No
change in load) for a certain amount of
time.
The vibration sensor will shut the lathe
motor off when it detects a vibration
above a certain threshold.
Advertisement
Table of Contents
