Table of Contents
Advertisement
Electrical Issue
SYMPTOM
NO Display screen
when the main power is on
Rotor Fault
RP State Error (0 or 1)
PFC Corrector (Flashing)
Please contact our customer service team as
Always isolate the lathe from its power source
before carrying out the following checking procedures
PLACE TO CHECK
10-pin ribbon cable
▪ Spindle
▪ Index Pin
Motor optical sensor
Headstock body
service@teknatool.com
WARNING
1. Dismount the HMI from the headstock
2. Unplug and re-plug the grey ribbon cable firmly as it
may have become loose during shipping
1. Check if the spindle index is engaged. Disengage the
spindle index if engaged.
2. Check if there is anything preventing the spindle to
turn
3. Remove the obstruction and try starting the motor
again
1. Turn the spindle by hand to see if this will cause a
breakthrough in the material that has built up around
the sensor.
2. Blow air through the headstock blowing away the
foreign material built up around the sensor.
1. CAREFULLY Touch the lower section of the headstock
and see if it is hot to the touch
2. Turn off the headstock main power switch and leave it
to cool down for a period of time. Restart the headstock
after it has cooled down.
if the above procedures did not resolve your issue.
34
128-1019-004
HOW TO RESOLVE
Advertisement
Table of Contents
