Setting Up Your Workshop; Workshop Requirements; Lathe Stand Recommendations - Teknatool NOVA 3000 Instruction Manual

Setting Up Your Workshop

Workshop Requirements

Consideration
Lathe
Location
Lighting
Electrical
Ventilation

Lathe Stand Recommendations

A sturdy and rigid stand is required so that the Nova 3000 Woodlathe can deliver optimum performance.
A common flaw with many woodlathe installations is an inadequate stand for the lathe. The larger the size
of your turnings, the greater the importance of the lathe stand design.
Consideration
Lathe Height
from floor
Stand Top
Stand Weight
Stand Legs
92-0106-017
Recommendation
Locate the Nova 3000 close to a power source in an area with good
lighting. Leave clearance to all sides of the lathe; allow for motor
clearance when the headstock is swiveled. Other machines in your
shop should not interfere with the operation of the lathe.
Your shop should have adequate lighting. The work area of the
lathe should be well lit; there should not be shadows cast on your
work. If possible, locate near a window. A movable spotlight may
be helpful.
The Nova 3000 requires the appropriate outlet nearby to power the
motor. Wiring and outlets should adhere to local electrical codes. If
in doubt, seek advice from an electrician. Minimize use of extension
cords.
Your shop should be adequately ventilated. The degree of
ventilation will vary based on the size of the shop and the amount of
work done. The use of dust collectors and filters will minimize risks
to your health.
Recommendation
The height of the stand should locate the centerline of the lathe
spindle at the elbow height of the turner.
The stand top should be flat so the lathe does not twist when it
is bolted down. Check for any gaps between lathe feet and
stand top before bolting down. Shim and prepare stand as
necessary..
The stand should have enough weight and mass so it doesn't
move when turning large work pieces, and so that the stand
can absorb vibrations. A lathe stand's stability can be improved
by weighing it down with sand bags on a lower shelf.
The stand should sit level on the floor and not rock.
9