Lathe Interface; Keypad Buttons; Lathe Home Screen - Teknatool nova ORION Series Operation Manual

3. Electrical
The NOVA Orion lathe requires an appropriate power outlet nearby to power the motor. The outlet wiring
must meet the local electrical safety standards. If in any doubt, seek advice from an electrician. The length
of an extension cable should be reduced as must as possible.
4. Ventilation
Workshop must have an adequate level of ventilation. The level of required ventilation depends on the size
of the workshop and the amount of work that is done within the workshop. The use of dust collectors and
filters will minimize your health risk.

Lathe Interface

Keypad Buttons

Lathe Home Screen

There are 2 home screen display modes available for the NOVA Orion lathe
LARGE NUMBER DISPLAY
The large number display will display:
▪ Set RPM of the lathe (When the motor is not turned
on). This will change to the actual RPM of the lathe
spindle when the motor is turned on.
NORMAL NUMER DISPLAY
The normal number display will display:
▪ Favourite speed assigned to each of the <F> keys.
▪ From the right, the favourite speeds are assigned to:
<F1>, <F2>, <F3>, <F4>
15
128-1019-004