7-7 Adjustment of the bobbin winder
(1) Adjustment of the winding volume
Loosen the setscrew
○
1 .If move the adjusting lever
lever
and if move the adjusting lever
increased.The winding volume is adjusted 80%of the full volume when the sewing machine is
shipped from the factory.
(2) Adjustment of the proper position of the bobbin winder Firstly . loosen the setscrews
the bobbin winder and put the empty bobbin
○
lever
1 to the arrow direction "a". Secondary. move the whole bobbin winder to the arrow direction
"C" and stop it at the position where the empty bobbin is rotated then,tighten the setscrews
○
4 of the bobbin winder.This is the proper position of the bobbin winder.
7-8 Adjustment of the work holder
(1) Turn the power switch off and
open the top cover of the
machine head.
(2) Loosen the screw
adjust position of the solenoid
○
1 . If the solenoid
moves arrow-A direction, the
work holder lift becomes higher,
and if moves arrow-B
direction, the work holder lift becomes lower.
(3) After the adjustment, tighten the screw
○
2 of the adjusting lever
○
1 to the arrow direction
○
2
and
○
1
○
2 securely.
○
1 and adjust the position of the adjusting
○
1 to the arrow direction "a" the Winding volume is reduced,
○
5 on the rotating shaft
17
"b", the winding volume is
○
3 and
○
6 then,push the adjusting
○
4 of
○
3 and