Care And Maintenance; Shell Cleaning; Interior Cleaning; Outer Surface Of The Face Shield - BRP Ski-Doo OXYGEN User Manual

F. CARE AND MAINTENANCE
WARNING WARNING
WARNING WARNING
Never use petroleum Never use Never use Never use petroleum petroleum petroleum- - - - based based based based chemicals, solvents, gasoline, cleaning agents or chemicals, solvents, gasoline, cleaning agents or chemicals, solvents, gasoline, cleaning agents or chemicals, solvents, gasoline, cleaning agents or
adhesives to clean the shell, liners or visors of your helmet. Your helmet shell, adhesives adhesives adhesives
liner and visors may be seriously damaged by the use of such products and
the full safety function of the helmet can then no longer be guaranteed.

1. SHELL CLEANING

To clean the helmet shell, you can use water, soap or one of the commonly
available motorcycle shampoos, cleaners, polishes, plastic cleaners or
cleaning fluids.
Using water and soap is usually sufficient. Make sure when using the other
cleaning materials that these do not come into contact with the face shield,
since they can cause damage to the visor and its coating.

2. INTERIOR CLEANING

The inner lining of the OXYGEN helmet can be removed completely.
The head and cheek pads can be washed by hand using a mild soap solution
(e.g. with highly diluted standard mild detergent) at a maximum temperature
of 30 °C.
Hand washing is recommended, but machine washing is also permitted. Use
the "delicate" cycle to prevent the agitator from damaging the sweat-wicking
material covering the liner parts. Allow the lining to dry at room temperature
and with good ventilation.
WARNING WARNING
WARNING WARNING
Do not place lining parts in the dryer: Excess heat may damage the foam and
coverings.

3. OUTER SURFACE OF THE FACE SHIELD

Use a soft cloth and a mild soap solution (< 20 °C) to remove dirt from the
outside of the face shield.
To dry the face shield, use a lint-free cloth and apply gentle pressure.
The face shield comes with a special fog resistant coating. This coating may
lose its effectiveness after approximately two years therefore we recommend
you replace your main visor with a new genuine one at least every two years.

4. HEATING LENS

The inside surface of the face shield must only be cleaned with a soft cloth,
which may be slightly dampened if required (we recommend a microfiber
cloth).
WARNING WARNING WARNING WARNING
Do not use any cleaning agents.

5. ELECTRICAL CONNECTIONS

Use a soft cloth and a mild soap solution (< 20 °C) to remove dirt from the
surface of the electrical connections.
To clean the pivot connections, remove the face shield and clean gently the
electrical contacts on both sides.
NOTICE NOTICE NOTICE NOTICE
Be very gentle on the spring blades, otherwise you could damage the electrical
contact.
23