Put The Helmet Off; Operating Instructions - BRP Ski-Doo OXYGEN User Manual

C. FIT & USAGE
3. CHECK YOUR FIELD OF VISION
Some helmets may obstruct or block your vision when looking left, right, up, or
down.
WARNING WARNING WARNING WARNING
Always make sure you can see well enough to safely operate your vehicle.
4. TEST THE HELMET FIT
Place your hands on each side of the helmet. While holding your head as
motionless as possible, try rotating your helmet from left to right then up and
down. You should feel the helmet move the skin on your head and face as you
try to move the helmet.
If it is not the case or if you can feel the helmet padding sliding on your head, it
is too big. If the helmet is constricting or painful, it is too small.
5. FASTEN THE CHIN STRAP
Tight it under your jaw until it remains no slack in the strap, and the strap must
be tight up against your jaw.
6. TEST THE CHIN STRAP FIT
• Put your hands on the back of the helmet (B) and try to push the helmet off
by rotating it forward.
• Put your hands on the front of the helmet above your forehead (or on the
chin guard) and try to push.
• If helmet comes off, try another size or model.
Repeat steps 1 through 6 until you find a helmet that fits your head snugly and
securely.

3. PUT THE HELMET OFF

1 1 1 1 . Make sure the sun visor is retracted into the helmet.
2. 2. 2. 2. Open the chinstrap.
3. 3. 3. 3. The helmet can now be removed easily from the head.
To avoid scratching any objects you might place the helmet on, we
recommend closing the chin-strap after you have taken the helmet off.

4. OPERATING INSTRUCTIONS

CONNECTING THE POWER CABLES
We highly recommend that you get your helmet cables connected by an
authorized BRP dealer so that he can refer to the vehicle's shop manual to
determine the best connection point.
18