Sun Visor - BRP Ski-Doo OXYGEN User Manual

B. THE HELMET
5 5 5 5 . . . . Once both sides are in position,
press the face shield pivots gently
towards the helmet with
simultaneous closing movement.
6 6 6 6 . . . . Make sure that the face shield
mechanism is functioning properly by
closing and opening the face shield to
its maximum extent.
a

7. SUN VISOR

OPERATION
The sun visor is operated by the lever
positioned on the left side of the helmet,
which makes it easy to use even when
wearing thick gloves.
Moving the lever upward lowers the sun
visor, moving it downward retracts the
sun visor inside the inner helmet shell
and locks it in position.
If during your ride you experience fogging or frosting on your sun visor,
raise it back to the up position, wait a minute, and then drop it back down. The
sun visor's upper storage position is heated, that will disperse any fogging that
may have occurred.
REMOVING THE SUN VISOR
1. 1. 1. 1. Pivot the sun visor in the lower position.
2. 2. 2. 2. Pull the sun visor downward until you
see the upper edge.
3. 3. 3. 3. Hold your helmet in position and pull
the sun visor on the right side, toward the
outside of the helmet.
4. 4. 4. 4. Repeat steps 2-3 for the other side.
The sun visor lever should remain in the
same position while you install the visor.
simply
1
2
9