Communication System Installation - BRP Ski-Doo OXYGEN User Manual

Hide thumbs Also See for Ski-Doo OXYGEN:
Table of Contents

Advertisement

C. FIT & USAGE

5. COMMUNICATION SYSTEM INSTALLATION

STEP 1
STEP 1
STEP 1
STEP 1
Remove the 2 Noise Control System (NCS) from your helmet and disassemble them.
STEP 2
STEP 2
STEP 2
STEP 2
Picture 1:
Picture 1:
Picture 1: If you have Velcro for your speakers, you can stick them to the bottom of the
Picture 1:
cup.
Picture 2: Install your speaker and position the wire in the notch as shown above.
Picture 2:
Picture 2:
Picture 2:
Picture 3: Put the white foam over the speaker.
Picture 3:
Picture 3:
Picture 3:
Picture 4:
Picture 4:
Picture 4: Position the NCS mesh on the top of it.
Picture 4:
STEP 3
STEP 3
STEP 3
STEP 3
Picture 1: Grab the NCS sub-assembly as shown above.
Picture 1:
Picture 1:
Picture 1:
Picture 2:
Picture 2:
Picture 2: Insert it into the cushion top side first, and the sides afterward.
Picture 2:
Picture 3: End with the bottom portion, make sure that the wire stays in position.
Picture 3:
Picture 3:
Picture 3:
Picture 4: The cushion must go over the cup, on the entire outline.
Picture 4:
Picture 4:
Picture 4:
STEP 4
STEP 4
STEP 4
STEP 4
Repeat these steps for the other NCS.
STEP 5
STEP 5
STEP 5
STEP 5
Picture 1:
Picture 1: Re-position the NCS inside your helmet and make sure the wires go out of
Picture 1:
Picture 1:
the NCS toward the rear of the helmet.
Picture 2: For the right speaker, hide the excess of wire behind the head liner in the
Picture 2:
Picture 2:
Picture 2:
neck area.
Picture 3: NCS installed and wires hidden behind head liner.
Picture 3:
Picture 3:
Picture 3:
STEP 6
STEP 6
STEP 6
STEP 6
For boom microphone
boom microphone
boom microphone communication systems, install the jog dial behind the side trim
boom microphone
fastener (as shown above).
For wired microphone
wired microphone communication systems, install the jog dial in front of the side
wired microphone
wired microphone
trim fastener (as shown above).
STEP 7
STEP 7
STEP 7
STEP 7
Position the boom microphone as shown above and then, reinstall the protective collar.
Boom
Wired
microphone
microphone
jog dial
jog dial
20

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents